- A crowding or flooding in.
Inrush current or input surge current refers to the maximum, instantaneous input current drawn by an electrical device when first turned on. For example, incandescent light bulbs have high inrush currents until their filaments warm up and their resistance increases. Alternating current electric motors and transformers may draw several times their normal full-load current when first energized, for a few cycles of the input waveform. Power converters also feature high inrush currents relative to their steady state currents. This is typically the charging current of the input capacitance. The selection of overcurrent protection devices such as fuses and circuit breakers is made more complicated when high inrush currents must be tolerated. The overcurrent protection must react quickly to overload or short circuit but must not interrupt the circuit when the (usually harmless) inrush current flows.
TransformersWhen a transformer is first energized a transient current much larger than the rated transformer current can flow for several cycles. This is caused because the transformer will always have some residual flux density and when the transformer is reenergized the incoming flux will add to the already existing flux which will cause the transformer to move into saturation.
ProtectionFor example, a resistor in series with the line can be used to limit the current charging input capacitors. However, this approach is not very efficient, especially in high power devices.
Inrush current can also be reduced by inrush current limiters: negative temperature coefficient (NTC) thermistors are among the most common design options used in switching power supplies, motor drives and audio equipment to prevent damage caused by inrush current. A thermistor is a thermally-sensitive resistor with a resistance that changes significantly and predictably as a result of temperature changes. The resistance of an NTC thermistor decreases as its temperature increases.
As the inrush current limiter self-heats, the current begins to flow through it. Its resistance begins to drop and a relatively small current flow charges the input capacitors. After the capacitors in the power supply become charged, the self heated inrush current limiter offers little resistance in the circuit. So low that the voltage drop is an insignificant factor with respect to the total voltage drop of the circuit.
Another option, particularly for high voltage circuits, is to use a pre-charge circuit. The circuit would support a current limited precharge mode during the charging of capacitors, and then switch to an unlimited mode for normal operation when the voltage on the load is 90% of full charge.
affluence, afflux, affluxion, air current, crosscurrent, current, current of air, downdraft, draft, fall wind, flow in, flow of air, following wind, head wind, indraft, indrawing, inflood, inflooding, inflow, influx, influxion, inhalation, inpour, inpouring, inrun, inspiration, jetstream, katabatic wind, monsoon, movement of air, pour in, stream, stream of air, tail wind, undercurrent, updraft, wind